30 Nosler
Hornady Unprimed Brass Cases 30 Nosler 20-Count Features:
Extra time and care is taken in the creation of their cases, producing smaller lots that meet strict quality standards. Their cases offer reloaders excellent uniformity in wall thickness weight and internal capacity. They measure for consistency tight wall concentricity and even run their cases through a pressure calibration test to ensure uniform case expansion during firing. Hornady’s cases allow proper seating of the bullet not only in the case, but in the chamber as well. High quality brass contributes to consistent charges and pressures. Tight Wall Concentricity- Concentricity helps to ensure proper bullet seating in both the case and the chamber of your firearm. Higher concentricity also aids in a uniform release of the bullet on firing, for optimal velocity and accuracy. Uniform Case Wall Thickness- Benchrest shooters have long known that uniform case wall thickness is vital to accuracy. We manufacture to extremely tight tolerances to ensure this critical element is as consistent as possible. More Reloads Per Case- We treat Hornady brass as the foundation for an accurate cartridge, not a commodity.
Because we take greater care in its creation you’ll get more reloads from Hornady brass. Consistent Weight and Capacity- Every single Hornady case, regardless of the lot in which it was produced, is virtually identical to other Hornady cases in the same caliber. For you, this means consistent pressures, velocity and accuracy — every time.
Hornady Unprimed Brass Cases 30 Nosler 20-Count Specifications:
Tight wall concentricity
Uniform case wall thickness
More reloads per case
Consistent weight & capacity
Caliber: .30 Nosler
Quantity: 20
About
Nosler brass by far better choice. Hell with the cost. It’s the cheaper part of the whole adventure. By the way my COL is 3.540, to ogive 2.770.
my info is just like the above and is spot on
.200-.230 fb will get you where you need to be with 210-215 berger thats where mine is
h1000 or retumbo will be the best from what ive found
there is absolutely nothing wrong with nosler brass
most all run in the mid 3000’s
.225 freebore, if you wanna just run your 30 Nosler just above 3000FPS then the Nosler brass primer pockets will probably last a little while. If you wanna run the next node up around 3100 then get ADG. I would get ADG brass. At 3100 after 2 firings with Nosler the primers will fall out.
